mirror of
https://github.com/torvalds/linux.git
synced 2024-11-22 04:38:03 +00:00
b0d3969d2b
Add initial support for Renesas Ethernet-TSN End-station device of R-Car V4H. The Ethernet End-station can connect to an Ethernet network using a 10 Mbps, 100 Mbps, or 1 Gbps full-duplex link via MII/GMII/RMII/RGMII. Depending on the connected PHY. The driver supports Rx checksum and offload and hardware timestamps. While full power management and suspend/resume is not yet supported the driver enables runtime PM in order to enable the module clock. While explicit clock management using clk_enable() would suffice for the supported SoC, the module could be reused on SoCs where the module is part of a power domain. Signed-off-by: Niklas Söderlund <niklas.soderlund+renesas@ragnatech.se> Reviewed-by: Andrew Lunn <andrew@lunn.ch> Signed-off-by: David S. Miller <davem@davemloft.net>
16 lines
319 B
Makefile
16 lines
319 B
Makefile
# SPDX-License-Identifier: GPL-2.0
|
|
#
|
|
# Makefile for the Renesas network device drivers
|
|
#
|
|
|
|
obj-$(CONFIG_SH_ETH) += sh_eth.o
|
|
|
|
ravb-objs := ravb_main.o ravb_ptp.o
|
|
obj-$(CONFIG_RAVB) += ravb.o
|
|
|
|
obj-$(CONFIG_RENESAS_ETHER_SWITCH) += rswitch.o
|
|
|
|
obj-$(CONFIG_RENESAS_GEN4_PTP) += rcar_gen4_ptp.o
|
|
|
|
obj-$(CONFIG_RTSN) += rtsn.o
|